5-17
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
Use
the
[
] [
] [
] [
]
keys
to move the pen carriage (the tip of the tool selected by the current setting) to the
desired new U.R. point and then press the
[ENTER] key
. At such time, the X= and Y= coordinate values respectively
represent the current pen carriage position as X- and Y-axis displacements from the original origin.
To select the default U.R. point, press the
[F3] key
(DEFAULT). You do not need to press the
[ENTER] key
if the
default U.R. point was selected.
(6) Press the
[PAUSE] key
to cancel PAUSE mode.
•
This setting returns to its default status when the power is turned off.
•
After this setting has been made, the origin moves to the same position as the lower left position
•
The L.L. and U.R. positions cannot be speci
fi
ed outside of the actual area of the loaded cutting medium.
•
The effective cutting area can only be set by specifying the lower left and upper right points. If the effective cutting
area is incorrectly speci
fi
ed (by, for example, specifying the upper left or lower right point or specifying lower left
and upper right points that are less than 5 mm apart in either the X or the Y axis, the message below appears for
several seconds. In this case, set the effective cutting area over again.
FORCE
OFFSET
SPEED
QUALITY
ILLEGAL PLOT AREA
•
When the ROTATE or MIRROR mode is selected or cancelled after specifying new L.L. and U.R. positions, your L.L.
and U.R. settings are initialized to their default positions (the lower left and upper right corners of the maximum
effective cutting area).
Summary of Contents for CUTTING PRO FC2250 Series
Page 1: ...USER S MANUAL MANUAL NO FC2250 UM 151 FC2250 SERIES CUTTING PRO www delinit by...
Page 104: ...5 29 Chapter 5 FUNCTION SETTINGS AND OPERATIONS Cutting Plotting Conditions List...
Page 120: ...CHAPTER 8 SPECIFICATIONS PRODUCT SUMMARY 8 1 Main Specifications 8 2 External Dimensions...
Page 129: ...www delinit by...
