5-19
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.17 Scaling the Image Data
This function is used to expand or reduce the image data using the program origin as the starting point.
(1) Press the
[PAUSE] key
to select PAUSE mode.
(2) Press the
[NEXT] key
repeatedly until the following menu is displayed.
FORCE
OFFSET
SPEED
QUALITY
I/F FUNCTION
TOOL COND AREA OPT
(3) Press the
[F4] key
(AREA OPT) to display the menu shown below.
FORCE
OFFSET
SPEED
QUALITY
ROTATE MIRROR
L.L. U.R. SCALE
(4) Press the
[F4] key
(SCALE) to display the scaling factor setting screen.
FORCE
OFFSET
SPEED
QUALITY
SCALE
SCALE = 1
Use
the
[
]
or
[
]
key
to change the numeric value, and then press the
[ENTER] key
to con
fi
rm your selection.
Scaling factors: 1 to 8, 1/8, 1/4, 1/2 (times)
The scaling factor value is increased by one increment by pressing the
[
] key
, or is decreased by one increment
in the sequence below by pressing the
[
]
key
.
2
1
7
8
1/8
1/4
1/2
(5) Press the
[PAUSE] key
to cancel PAUSE mode.
•
This setting returns to SCALE =1 when the plotter is turned off.
•
When expansion was speci
fi
ed and the data values are too high, the data outside the plotting area is not cut and the
red PROMPT lamp on the control panel lights. In that case, either reduce the data values or lower the scaling factor.
Summary of Contents for CUTTING PRO FC2250 Series
Page 1: ...USER S MANUAL MANUAL NO FC2250 UM 151 FC2250 SERIES CUTTING PRO www delinit by...
Page 104: ...5 29 Chapter 5 FUNCTION SETTINGS AND OPERATIONS Cutting Plotting Conditions List...
Page 120: ...CHAPTER 8 SPECIFICATIONS PRODUCT SUMMARY 8 1 Main Specifications 8 2 External Dimensions...
Page 129: ...www delinit by...
