Background Settings
♦
C5 - 5
LENGTH UNIT
METRIC
\
\
INCH
PEN UP MOVE
ENABLED
DISABLED
\
\
INITIAL BLADE
CONTROL POSITION
2mm BELOW
\
\
OUTSIDE
LENGTH UNIT
METRIC
\
\
INCH
Initial Blade Control Position (INIT. BLADE CONTROL)
This function specifies the position at which initial blade control is performed (for more information
about initial blade control see
Adjusting the Blade Offset Angle
.)
When 2 mm BELOW is selected, initial blade control is performed 2 mm below the starting point
of cutting.
When OUTSIDE is selected, initial blade control is performed outside of the effective cutting area.
Press the F3 key to select 2 mm BELOW.
Press the F4 key to select OUTSIDE.
An asterisk appears beside your choice.
Press the ENTER key to register your setting and to
proceed to the next menu.
Press the NEXT key if you wish to bypass this setting
with no changes.
If you do not wish to make any changes on the background
settings, turn off the plotter.
Length Unit
This selection enables one to set the unit for coordinates appearing on the display panel to either
units of millimeters or inches.
Press the F3 key to select METRIC.
Press the F4 key to select INCH.
An asterisk appears beside your choice.
Press the ENTER key to register your setting and to
proceed to the next menu.
Press the NEXT key if you wish to bypass this setting
with no changes.
If you do not wish to make any changes on the background
settings, turn off the plotter.
Summary of Contents for Cutting Pro FC4100-100
Page 1: ...cutting pro FC4100 series series USER S MANUAL 1 a...
Page 138: ...Setting the Interface Functions C7 7 Input Output Circuitry Input Output Timing Chart...
Page 147: ...Specifications C8 6 FC4100 100 without Stand FC4100 100 with Stand Standard and Basket Option...
Page 148: ...Specifications C8 7 FC4100 130 without Stand FC4100 130 with Stand Standard and Basket Option...
