Options
♦
C9 - 1
Chapter 9 Options
The following are the FC4100 option user manuals.
FC4100 Pounce Tool Manual
Pouncing is a method used to create a punched outline on media. This is done by inserting a
special tool in the plotter that produces holes instead of plotting with a pen or cutting with a blade.
This outline or pattern has many uses such as aligning letters on a large job or creating a chalk
outline for graphics that will be hand-painted.
The pounce tool has a small point that is pressed into the media. The pounce conditions are set
from the conditions menu.
Force:
Sets the hole punching force during pouncing.
Speed:
Sets the traveling speed of the lowered pouncing tool.
Quality:
Sets the acceleration rate of the pouncing tool.
Offset:
Sets the spacing between holes in mm units.
WARNING:
To prevent bodily injury, handle the pouncing tool with care.
n
Pounce tool points are very sharp. While handling the
pounce tool be careful to avoid cutting your fingers or other
parts of your body.
Sharp
Summary of Contents for Cutting Pro FC4100-100
Page 1: ...cutting pro FC4100 series series USER S MANUAL 1 a...
Page 138: ...Setting the Interface Functions C7 7 Input Output Circuitry Input Output Timing Chart...
Page 147: ...Specifications C8 6 FC4100 100 without Stand FC4100 100 with Stand Standard and Basket Option...
Page 148: ...Specifications C8 7 FC4100 130 without Stand FC4100 130 with Stand Standard and Basket Option...
