Preparing to Cut
♦
C3 - 18
CUT AREA
X= 2000mm Y= 730mm
ROLL-1>
ROLL-2>
SHEET>
CONTINUE>
CUT AREA
X= 2000mm Y= 730mm
ROLL-1>
ROLL-2>
SHEET>
CONTINUE>
ROLL-1>
ROLL-2>
SHEET>
CONTINUE>
Select the Media Type
CAUTION:
To avoid damaging the cutting mat, make sure to set the media type to SHEET
when using sheet media. Whenever as possible, use sheet media of
rectangular shape.
If you have already loaded media, the media type menu appears.
Select the media type.
ROLL–1
Detects the leading edge of the roll media. The coordinate origin is initialized with respect to the
media’s leading edge.
Press F1 key to select ROLL-1
The initialization routine is executed to determine the paper size
and origin point.
Then CUT AREA shows the effective cut area that is determined
by the position of the pinch roller and the page length setting.
ROLL–2
The leading edge of the roll media is not detected and the coordinate origin is initialized with
respect to the cutting mat.
Press F2 key to select ROLL-2
The initialization routine is executed to determine the paper size
and origin point.
Then CUT AREA shows the effective cut area that is determined
by the position of the pinch roller and the page length setting.
NOTE:
After initializing the plotter by choosing ROLL-1 or ROLL-2, use the FEED function to
pre-feed the length of media needed for the job. This embosses the grit roller pattern
onto the media to help prevent media skewing or excessive system torque which
triggers the position alarm. The position alarm resets the system or if the system is
overloaded, it triggers the product’s circuit protection causing power to shut down.
Should the system overload, causing the power to shut down, turn off the power
switch and unplug the power cord. After 5 to 10 minutes, connect the power and turn
on the system. For more information, see
Chapter 6 Test Modes and
Troubleshooting
.
Summary of Contents for Cutting Pro FC4100-100
Page 1: ...cutting pro FC4100 series series USER S MANUAL 1 a...
Page 138: ...Setting the Interface Functions C7 7 Input Output Circuitry Input Output Timing Chart...
Page 147: ...Specifications C8 6 FC4100 100 without Stand FC4100 100 with Stand Standard and Basket Option...
Page 148: ...Specifications C8 7 FC4100 130 without Stand FC4100 130 with Stand Standard and Basket Option...