Preparing to Cut
♦
C3 - 24
SET 14
CONDITION 2 30
4
zz
CB09Ux 0
SET 14
CONDITION 2 30
4
CB09Ux 0
zz
To Change the Cutter Quality
Press the F3 key to change QUALITY. The blinking
cursor indicates that you can change its setting.
Press the UP or DOWN ARROW key to raise or lower
the numeric value from 1 to 8. The smaller the value,
the higher the quality.
Press the F1 key to change FORCE.
Press the F2 key to change SPEED.
Press the F4 key to change OFFSET.
Press the ENTER key to register your setting.
To Change the Cutter Offset
Press the F4 key to change OFFSET. The blinking
cursor indicates that you can change its setting.
Press the UP or DOWN ARROW key to raise or lower
the numeric value from –5 to +5.
For more
information, see
Running Cutting Test.
Press the ENTER key to register your setting.
Fine Adjustment
1. Set the blade type to OTHER to permit fine adjustment of the CUTTER OFFSET value.
2. While referring to the figures above, gradually adjust the cutter offset value while checking the
results by running a cut test.
Summary of Contents for Cutting Pro FC4100-100
Page 1: ...cutting pro FC4100 series series USER S MANUAL 1 a...
Page 138: ...Setting the Interface Functions C7 7 Input Output Circuitry Input Output Timing Chart...
Page 147: ...Specifications C8 6 FC4100 100 without Stand FC4100 100 with Stand Standard and Basket Option...
Page 148: ...Specifications C8 7 FC4100 130 without Stand FC4100 130 with Stand Standard and Basket Option...