Preparing to Cut
♦
C3 - 26
CONDITION 2 14
30
READY 4
CB09Ux 0
TEST 1>
TEST 2>
CUTTING PRO>
CONDITION 2 14
30
READY 4
CB09Ux 0
TEST 1>
TEST 2>
CUTTING PRO>
Test 1
Use this TEST 1 pattern to test your condition settings.
With the media loaded in the plotter and the READY or PAUSE
mode displayed on the menu,
Press the TEST key on the Control Panel. You will
see the following test menu.
Press the F2 key to select TEST 1.
The plotter immediately cuts one (1) triangle from the current pen position.
n
Adjust the cutting conditions and re-run the cutting test.
n
Repeat this process until you achieve the desired results.
Press the ENTER key to return to the READY mode
when the results are satisfactory.
Test 2
If you feel you have almost achieved the best condition, use the TEST 2 pattern. This test cuts
three triangle patterns in 3 different cutting forces. The center triangle is cut using the force you
selected. The left triangle is cut using a force that is one step lower than your selection. The right
triangle is cut using a force that is one step higher than your selection. This allows you to confirm
that your force selection is the best.
With the media loaded in the plotter and the READY or PAUSE
mode displayed on the menu,
Press the TEST key on the Control Panel. You will
see the following test menu.
Press the F3 key to select TEST 2.
The plotter immediately cuts three (3) triangles from the current pen position.
n
Adjust the cutting conditions and re-run the cutting test.
n
Repeat this process until you achieve the desired results.
Press the ENTER key to return to the READY mode
when the results are satisfactory.
Summary of Contents for Cutting Pro FC4100-100
Page 1: ...cutting pro FC4100 series series USER S MANUAL 1 a...
Page 138: ...Setting the Interface Functions C7 7 Input Output Circuitry Input Output Timing Chart...
Page 147: ...Specifications C8 6 FC4100 100 without Stand FC4100 100 with Stand Standard and Basket Option...
Page 148: ...Specifications C8 7 FC4100 130 without Stand FC4100 130 with Stand Standard and Basket Option...