Advanced Functions and Settings
♦
C4 - 20
MIRROR
ON
\
\
OFF
ROTATE>
MIRROR>
SCALE>
INTERFACE>
AREA PARAMETERS>
FUNCTION 1>
FUNCTION 2>
MIRROR – Reversing the Image
To cut a reversed image of the original data, use the mirror mode. When the mirror mode is
enabled, the origin and coordinate axes are changed as shown in the figure below. A mirror
image of the original data is cut.
Press the MENU key to select MENU mode.
Press the NEXT key.
Press the NEXT key again.
Press the F3 key to select FUNCTION1.
Press the F3 key to select MIRROR.
Press the F3 key to turn ON the function.
Press the F4 key to turn OFF the function.
Press the ENTER key to register your settings.
Press the MENU key to cancel MENU mode.
When the MIRROR mode is selected or canceled, the displacement of the new origin remains
valid in the “a” direction, but is reset to its default position in the “b” direction.
Before MIRROR is selected
After MIRROR is selected
Summary of Contents for Cutting Pro FC4100-100
Page 1: ...cutting pro FC4100 series series USER S MANUAL 1 a...
Page 138: ...Setting the Interface Functions C7 7 Input Output Circuitry Input Output Timing Chart...
Page 147: ...Specifications C8 6 FC4100 100 without Stand FC4100 100 with Stand Standard and Basket Option...
Page 148: ...Specifications C8 7 FC4100 130 without Stand FC4100 130 with Stand Standard and Basket Option...