FC2240-UM-251-9730
3-5
3. OPERATIONS
3.4 Adjusting the Pen Carriage Height
S
Initial adjustment of the pen carriage height
1. Use the hexagon wrench to loosen the height adjustment bolt.
2. When the pen carriage can be moved freely up and down, insert the height
adjustment plate (thick) under the pen carriage. Adjust the height of the pen
carriage so that the pen carriage rests on top of the plate.
3. Use the hexagon wrench to tighten the height adjustment bolt. Make sure that the
pen carriage is parallel to the writing panel.
4. When the adjustment is complete, remove the height adjustment plate (thick) from
under the pen carriage.
S
Height adjustment during cutter pen installation
1. Loosen the pen holder section screw and mount the pen.
2. Insert the height adjustment plate (thin) under the pen and adjust the height.
3. After mounting the pen, tighten the screw.
4. When the adjustment is complete, remove the adjustment plate (thin) from under
the pen.
CHECKPOINT
Always make sure that the writing panel is in a horizontal position before making this adjustment. When
cutting thick media, place the medium on the writing panel before making this adjustment.
Summary of Contents for FC2240
