FC2240-UM-251-9730
3-10
3. OPERATIONS
Procedure
With the plotter in Ready status, press the [F1] through [F4] key corresponding to the number of the group
for which you wish to make settings. The setting condition numbers (CONDITION 1 to 8) are assigned to the
[F1] through [F4] keys.
For example, if the [F1] key is pressed when CONDITION 1 has been selected, the display changes to
CONDITION 5. If a condition number other than 1 was selected, CONDITION 1 will be displayed when the
[F1] key is pressed. In the same way, press [F2] to select CONDITION 2 and 6, [F3] to select CONDITION 3
and 7, and [F4] to select CONDITION 4 and 8.
(1) Press the [CONDITIONS] key. The lower row of the display changes from "READY" to "SET COND”.
(2) A menu similar to the example below is displayed. In this example, the factory default setting COND 2
has been selected. (Items displayed may differ for other COND numbers).
FORCE
OFFSET
SPEED
QUALITY
Blinking cursor
14 COND2 09U 0
20 SET COND 3
(3) Move the blinking cursor next to the setting you wish to change.
(4) The cursor will move each time you press one of the keys [F1] to [F4] keys.
(5) Change the displayed setting next to the blinking cursor as follows.
To raise a numeric value, press the [
] key.
To lower a numeric value, press the [
] key.
(6) Press the [F3] key to select the blade type. Use the [
] or [
] key to move through the selection.
The table below describes the specifiable range for each condition.
Condition
Range
Remarks
FORCE
Pen 1: 1 to 40
Pen 2: 2 to 80
40 steps
40 steps, even numbers only.
SPEED
1 to 40
40 steps in cm/s units.
OFFSET
-5 to +5
Select 0 for automatic adjustment according to the blade type.
QUALITY
1 to 6
The lower the number, the higher the quality.
Summary of Contents for FC2240
