FC2240-UM-251-9370
8-16
8. ELECTRICAL ADJUSTMENTS
8.12 Adjusting the Distance and the Perpendicularity Accuracy
This adjustment will set the distance and the perpendicularity accuracy.
If you replace the main board or clear the Non-Volatile RAM, use the following procedure to input the
recorded adjustment values.
How to adjust the distance accuracy
(1) Mount a ceramic pen (0.2 mm tip size) in the No.1 pen holder.
(2) Load a sheet of A1 or A2 size paper in the plotter.
(3) Set the DIP switch to the adjustment mode as shown below.
Electrical Adjustments
Set bits 4, 5, and 6 to OFF
1 2 3 4 5 6 7 8
ON
OFF
(4) Turn on the power to the plotter.
(5) Press the [NEXT] key until the following menu is displayed.
DIST. ADJ. (0.01mm)
PRESS ENTER KEY !!
(6) Press the [Enter] key to display the menu shown below.
SEl SIZE 300x300
200x200 500x700
(7) Press the [F4] key to select the 500x700 mm adjustment pattern.
(8) Press the [Enter] key to display the menu shown below.
<ORIGINAL CLEAR>
<ADJ.DRAW INPUT>
F1 key (ORIGINAL)
:Draw the test pattern without distance adjustment.
F2 key (ADJ. DRAW)
:Draw the test pattern with distance adjustment.
F3 key (CLEAR)
:Clear the distance adjustment value.
F4 key (INPUT)
:Move to the distance adjustment value setting menu.
(9) Press the [F1] key to start the test. The plotter immediately plots the test pattern, and the following menu
appears.
DIST. ADJ. (0.01mm)
X =+10 Y =-10
Y=700 mm
X=500 mm
Summary of Contents for FC2240
