SENSOR OFFSET ADJUST
Per Graphtec we need to begin using “Sensor Offset Adjust” rather than “Axis Origin Offset.” Both methods
result in shifting the cut lines but, the Sensor Offset Adjust will NOT move the ORIGIN point.
REMEMBER: Increase the X and Y values shift the cut lines to the upper left if you are standing in front
of the cutter.
Y = (right to left, positive values shift left), X = (down to up, positive values shift cut lines up)
1.)
Ensure the customer has “Ready” displayed on the screen.
Hit F1 to be sure you are editing the correct condition
2.)
Hit the “AXIS/RMS Key”
3.)
Hit “F1” for Auto Reg Mark
4.)
Hit “F3” for Other Setups
5.)
Hit “F2” Sensor Offset Adjust
6.)
Hit “F3” for Method 1
7.)
Hit “F3” for Parameter Set
8.)
Arrow up or down to change X and Y Axis. Hit “Enter” to confirm.
