FC9000-UM-251-9370 9-19
9 TROUBLESHOOTING
Error
code
Error Display
Verification item
Cause
Solution
E02005
Confirm correct
device is selecting
when the windows
driver is using.
The software
configuration
regarding the output
device has been
changed.
Select the correct
device.
When the RS-232C
interface is using,
confirm transport
setting.
The plotter’s interface
conditions have been
changed.
Re-specify the software
application’s interface
conditions.
E02006
Confirm the out put
setting of application
software.
Data is exceeding the
cutting area.
Set correct output
setting.
E02008
Confirm there is
enough media size to
cut this job.
Media end was
detected.
There is not enough
media to cut it.
Load the roll media that
have enough cutting
area.
Summary of Contents for FC9000-100
