FC9000-UM-251-9370 8-5
8 Electrical Adjustment
8.2.7 When the cam sensor board was replaced
When the cam sensor board was exchanged, perform the following adjustment.
Back up the adjustment value to the SUB-NVRAM (Refer to subsection 8.21.).
End of adjustment
8.2.8 When the optional 2nd pen was installed
When the optional 2nd pen was installed, perform the following adjustments.
Set the dip switch for corresponding 2nd pen model (Refer to subsection 8.3.).
Adjust the 2nd Pen Exchange position (Refer to subsection 8.18.2.).
Adjust the Spacing Between Tool 1 and Tool 2 (Refer to subsection 8.19.2.).
End of adjustment
8.2.9 When the optional 2nd pen of holder or station was replaced
When the optional 2nd pen of holder or station was replaced, perform the following adjustment.
Adjust the 2nd Pen Exchange position (Refer to subsection 8.18.2.).
Adjust the Spacing Between Tool 1 and Tool 2 (Refer to subsection 8.19.2.).
End of adjustment
8.2.10 When the optional push roller was installed
When the optional push roller was installed, perform the following adjustment.
Set the Number of Push Rollers (Refer to subsection 8.20.)
End of adjustment
8.2.11 When the gird roller was replaced
When the gird roller was replaced, perform the following adjustment.
Adjust the Distance and the Perpendicularity Accuracy adjustment values (Refer to subsection 8.13.2.).
End of adjustment
Summary of Contents for FC9000-100
