FC9000-UM-251-9370 3-1
3 PARTS NAMES and FUNCTIONS
3 PARTS NAMES and FUNCTIONS
3.1 Parts Names and Functions
Front View
Power switch
Cutting groove
Cutting mat
Push roller
Grit roller
Media sensor
Cross cutter unit
Push roller
positioning guide
Tool carriage
Tool holder
Media Set lever
Control panel
Media stopper
Pen station
Pen holder
(Optional)
(Optional)
Power switch
: Used to turn the plotter on and off
Control panel
: Used to access various plotter functions
Pinch rollers
: Rollers that push the media against the grit rollers
Grit rollers
: Metallic rollers with a file-like surface that feed the media back and forth
Media sensors
: The front sensor is used to sense the leading edge of the media The rear
sensor is used to sense the trailing edge of the media
Tool carriage
: Moves the cutter-pen or plotting pen across the media during cutting or plotting
Tool holder
: Holds the cutter-pen or plotting pen and moves it up or down
Pen station, pen holder
: Second pen is mounted here (installed on 2-pen models only)
Grit roller position guide
: Stickers on the front of top cover that show the position of each grit roller Use
these alignment marks as an aid in locating the pinch rollers
Cutting mat
: Cutter blade moved on this mat, preventing wears of the blade
Cutting groove
: Used when cross-cutting is performed
Cross-cutter unit
: Used to perform cross-cutting of media so that the cut length can be removed
from the roll
Media Stopper
: Used to prevent the stock rollers from rotating when the media roll has been
placed on top of them The media lock ensures that the media is pulled straight
out from the roll
Media set lever
: Used to raise or lower the pinch rollers during the loading or unloading of media
Summary of Contents for FC9000-100
