4-19
4.12
BAR CODE
Set the bar code from the “BAR CODE”.
When the bar code is printed by the DLP1000, the bar code to identify the print data can be added.
Usually, set to “ENABLE”.
Due to the media to be sensed and the bar code printing state, the machine may fail to sense the bar code. In such the
case, “ENABLE” should be changed to “DISABLE”. By doing so, the sensing of the registration mark is not performed.
If set to "ENABLE", the machine reads in the printed bar code with the sensor in the cutter unit and determines if
the code matches with the code stored in the transferred data.
If matched, the cutting operation is performed continuously.
If not matched, the cutting operation is suspended and the message is displayed and then a key input is requested.
When “DISABLE” is set, the match determination of bar code, such as when to set to “ENABLE”, is not
performed. (Since it does not take action to sense the bar code, the total processing time will be shorter.)
Operation
1
3UHVVWKH>0(18@NH\LQ5($'<VWDWXV
MENU screen is displayed.
2
Press the POSITION (
) keys to select “CHANGE
6(77,1*6µ7KHLWHPLVKLJKOLJKWHG7KHQSUHVV>(17(5@NH\
CHANGE SETTINGS screen is displayed.
3
Press the POSITION (
) keys to select “MARK”. Then,
SUHVV>(17(5@NH\
MARK screen is displayed.
