6-6
LCD Display
Cause
Solution
The load to cross cut unit is large,
and the current to the motor
H[FHHGVVSHFLÀFDWLRQV
Remove the factors that interfere with the
operation and turn off the power then turn on
again.
The separator (weeding) is not
separating.
If the media is not separated (weeded), the
cross cut cannot be performed well.
Separate the media properly.
The load to winding motor 1 is
large, and the current to the motor
H[FHHGVVSHFLÀFDWLRQV
Remove the factors that interfere with the
operation and turn off the power then turn on
again.
The load to winding motor 2 is
large, and the current to the motor
H[FHHGVVSHFLÀFDWLRQV
Remove the factors that interfere with the
operation and turn off the power then turn on
again.
The load to winding motor for
laminate backing sheet is large, and
the current to the motor exceeds
VSHFLÀFDWLRQV
Remove the factors that interfere with the
operation and turn off the power then turn on
again.
Since the winding amount of the
separator (weeding) became thick
(Scrap amount was increased), the
separator can no longer be rotated.
Replace the bobbin wound the media with the
new one.
The load to separator (weeding)
motor is large, and the current to
WKHPRWRUH[FHHGVVSHFLÀFDWLRQV
Remove the factors that interfere with the
operation and turn off the power then turn on
again.
8QUHFRJQL]DEOHGDWDZDVUHFHLYHG
Check the data.
The cutter unit is not turned on.
The cable connected to the cutter
unit is disconnected.
Check the power cable, power switch, and
connection cable in the cutter unit.
(Internal or communication error
occurs, rather than the above
cause) when this error frequently
occurs, please contact the
distributor where you purchased
this product or your nearest
Graphtec vender.
Please contact the distributor where you
purchased this product or your nearest Graphtec
vender.
