1-3
1.2
Nomenclature
(1) Roll holder
(2) Roll stocker cover
(3) USB interface
(4) Network interface
(5) Control panel
(6) Cutter unit
(7) Set lever
(8) Dancer roller 2
(9) Ejection roller lever
(11) Separator winder bobbin
(11) Separator suppression unit
(Brush part)
(12) Press roller lever
(11) Press roller
(1) Roll holder ...........................Use the Flange A and Flange B to align the roll paper in the proper position.
(2) Roll stocker cover ................This is used to protect the location to set the roll holder.
(3) USB interface ......................Connector used when connecting this device via USB I/F.
(4) Network interface ................Connector used when connecting this machine via network I/F.
(5) Control panel .......................Carry out operations and various settings.
(6) Cutter unit ............................Cuts (stenciling, frame-cutting) media.
(7) Set lever ..............................When loading the media to the cutting part, raise and lower the push roller to
UHOHDVHDQGÀ[WKHPHGLD
(8) Dancer roller 2 ....................Used when setting/feeding media.
(9) Ejection roller lever .............When loading the media, use this lever to open and close the ejection roller.
(10) Separator winder bobbin ...Rolls up detached unnecessary media.
When the separator is not used, it must not be removed.
(11) Separator suppression unit (Brush part)
.........................................This is used as a media holding and a route when unnecessary media is peeled
off.
(12) Press roller lever ................Opens and closes the press roller when the media is set.
(13) Press roller ........................Thrusts the media into the feed roller.
