1-4
(1) Power switch
(2) AC line inlet
(3) Roll holder 2
(4) Winding stocker cover 2
(5) Slitter unit
(6) Cross cutter unit
(7) Ejection roller
(8) Separator unit
(9) Dancer roller 1
(10) Emergency Stop Switch
(11) Laminate holder
(12) Laminate winder bobbin
(13) Stand
(3) Roll holder 1
(4) Winding stocker cover 1
(14) Stand opening
(1) Power switch .......................Switch for turning the power on/off.
(2) AC line inlet .........................Connector that connects the power cord.
(3) Roll holder (1 and 2) ...........Use the Flange A and Flange B to align the roll paper in the proper position.
(Winding part)
(4) Winding stocker cover (1 and 2)
.........................................This is used to protect the location to set the roll holder.
(5) Slitter unit ............................This is used to width-cut (longitudinal cut) the roll paper.
(6) Cross cutter unit ..................
&XWWHUXVHGIRUFURVVFXWWLQJKRUL]RQWDOFXWWLQJPHGLD
(7) Ejection roller ......................The media is pressed against the lower roller and is fed.
(8) Separator unit ......................Set when unnecessary media is detached.
(9) Dancer roller 1 ....................Used when setting/feeding media.
(10) Emergency Stop Switch
.........................................Press to stop the machine. Please use this in case of emergency.
(11) Laminate folder ..................Sets the laminate.
(12) Laminate winder bobbin ....Rolls up the laminate backing sheet.
(13) Stand .................................A stand to put the machine on.
(14) Stand opening ....................Unnecessary media edge that was cut in the slitter enters in the stand through
the bottom of this Cutter.
If necessary, please prepare the receiving box such as a paper box, etc.
