10
8960ENC Instruction Manual
Installation
Frame Sync Submodule (8900FSS)
An optional Frame Sync submodule is available for providing frame syn-
chronization to an external reference. The submodule installs on the
8960ENC circuit board.
Installation
Install the submodule onto the main circuit board by lining up the two con-
nectors on the submodule with the connectors on the module. Make sure
the connectors are aligned properly then press to seat the submodule.
Insert and tighten the center screw to secure the submodule and assure that
the connectors are in proper alignment.
Termination
When used on the 8960ENC host module, the Frame Sync Submodule ref-
erence signal input termination should be set to high impedance (see
Figure 3. Frame Sync Submodule Reference Signal Termination Selection
8900FSS
0642-0
8
r1
Temination
jumpers in
high impedance
position
JP3 NTSC
Ref.
JP4 PAL
Ref.
75
75
HI IMP
HI IMP
Insert and tighten screw
to secure submodule.
Summary of Contents for 8960ENC -
