For redundant SAN B side any network interface of type
iSCSI
Setting...
iSCSI (Secondary Redundant) is required
Network
Static is required.
Address
Allocation
The IP address for this interface on the network. Required.
IP Address
The networks listed in the Edit IP Address dialog box are those currently
defined in the system description, with available settings restricted according
to the network definition. If you require settings that are not available, you
can close dialog boxes and go to the
Network Configuration | Networks
tab to
modify network settings, then return to the Edit IP Address dialog box to
continue.
8. When you have verified that the planned settings are correct, click
OK
, then
Yes
to apply settings to the device and close.
A Contacting Device message box reports progress.
9. After configuring control network settings, do the following
a) If a message informs you of a possible loss of communication, click
OK
.
This message is normal, since this is the network over which you are currently
communicating.
b) In the Device list view, observe the device icon and wait until the icon displays
the green star overlay before proceeding.
The icon might not display the green star overlay for several seconds as
settings are reconfigured and communication is re-established.
c) In the Interface list view, right-click the interface and select
Ping
.
The Ping Host dialog box opens.
If ping status reports success, the interface is communicating on the control
network.
Adding Aurora Edit LD workstations for software deployment
If you have Aurora Edit LD workstations on the corporate LAN, use this topic to get
the workstations communicating with SiteConfig in order to support software
deployment. Do not attempt to use device discovery.
4 October 2010
Aurora Edit Installation Guide
53
Configuring the network