Tracking System Keypad
Check the
KEYPAD ADDRESS
rotary switch (located in the battery compartment of the
keypad) and verify that the selected setting corresponds to the setting of the
BASE UNIT
ADDRESS
switch on the back of the autoTRACK camera. If the two are different, adjust them
so that they correspond.
For more information on configuring the
BASE UNIT ADDRESS
on the camera and
keypad, see page 7 in the
Installation and Operations Manual
that came with the
camera.
If the Tracking System Keypad is being used in the wireless RF mode:
1. Install the supplied AA batteries in the Tracking System Keypad by removing the
battery door and inserting the batteries into the battery compartment.
2. After installing the batteries, replace the battery door and press one of the pan keys.
3. Look to verify that the LED on the front of the keypad illuminates. This indicates that
the batteries are installed properly.
If the light does not illuminate, the batteries may be installed backwards. Reverse
the way the batteries are inserted, and try again.
If the batteries are inserted improperly, it will not damage the keypad, the
keypad will simply not work.
If the Tracking System Keypad is being used in the hard-wired mode, connect the CameraMan
Keypad Cable to the
RJ-11
type jack located in the battery compartment of the Tracking
System Keypad.
You do not need batteries installed in the Tracking System Keypad when it is being
used in the hard-wired mode.
Press the
PAN
and
TILT
arrows one at a time and verify that the camera is responding to the
keypad. The
COM
light on the front of the camera should flash with every command received
by the camera. If the
autoTRACK
light on the front of the camera is not illuminated, press one
of the four
autoTRACK View
buttons on the keypad. This should cause the
autoTRACK
light
to begin flashing.
Refer to pages 15 through 22 for details on using the Tracking System Keypad.
Keypad Address
Tracking System Keypad
in hard-wired mode
Battery
compartment
