Encore — Configuration Manual
309
Overview
How Tie-Line Manager Works
The Tie-Line Manager application does not control routing matrices
directly. For system tie-lines, Tie-Line Manager works in conjunction with
the Router Controllers of the matrices involved the tie-line path. When a
Router Controller receives a panel or other request to connect a Destination
in its matrix to a Source outside its matrix (which is inaccessible directly), it
sends a request to Tie-Line Manager. Tie-Line Manager then checks glob-
ally for that Source, finds an available tie-line, and then issues appropriate
commands over the network to the required Router Controllers to create
that route. Because wider searches are involved, multiple tie-line hops can
greatly increase the processing requirements for finding tie-line paths. You
should configure the minimum number of hops possible to meet your tie-
line path requirements. We also recommend running Tie-Line Manager on
a dedicated processor, especially if multiple-hops are allowed.
TLM messages are time stamped when logged to the console, which can
assist with troubleshooting.
Tie-Line Properties and Restrictions
•
Tie-line Sources are router Destinations, and tie-line Destinations are
router Sources.
•
Each hop can use only a single tie-line. It is not possible to use multiple
tie-lines providing different Levels within a hop.
•
Local tie-lines can link the matrices of one Router Controller, but are
still managed by the Tie-Line Manager.
•
Overall operation of tie-lines can be configured to have:
Auto Ownership
- When the Tie-Line Manager learns over the network that
a route has happened which uses a tie-line, it adds that Destination as
a user of that tie-line.
Share Reserved
- Allows another user to use a reserved tie-line if it calls
for the same Source as the reserved user.
Don’t Care Lvls
- Allows tie-lines to be established using a tie-line Source
(router Destination) with Levels that don’t match those of the tie-line
Destination (router Source).
Park Ties on Release
- Each physical matrix may have a Source configured
as its park input, which can be selected automatically when a tie-line is
released.
•
Tie-lines use the best path (of all possible paths) when Tie Lines of type
Rooms (vs. Sharing) are used along with other types of Tie Line.
Summary of Contents for Encore
