10
Setting Up Your Multiviewer
Networking Setup
Display from output (partial view) showing dashboard at the bottom right
Enlarged view of dashboard.
Using the Kaleido-RCP2 with Default Settings
To start using the Kaleido-RCP2 with its default settings
1 Physically connect the Kaleido-RCP2 unit to the network using an Ethernet cable (see
Cabling Diagram
, on page 8).
By default, the Kaleido-RCP2 is configured with DHCP enabled, so it will automatically
be assigned an IP address by a DHCP server. If no DHCP server can be found, the
Application version
Frame IP address
System name
Room name
Note:
The Kaleido-RCP2 unit is optional and is not included in the standard
Kaleido-X16 package.
USO
RESTRITO