Operating instructions | Access and Security
4-8
Operator files
Both the user's card and the owner's card allow two different operator files to be
stored on the card. The recall and storage of a operator file is carried out via the
Files menu of the menu system. An operator file contains information relating to
the set-up of general camera preferences.
4.4.2 Access control
The owner’s card or the PIN code is used to access special set-up and security
features of the camera. Inserting the owner’s card into the camera gives direct
access to the Security menu. If you select the Security menu without this card
inserted, you must enter the correct PIN code to gain access to this menu.
PIN code
The PIN code of the camera can be viewed and changed in the Security menu. The
camera's PIN code when it leaves the factory is set to 0000. It is strongly advised
that this code be changed by the owner on receipt of the camera. This ensures
added protection against unaurthorised access to the Security menu.
4.4.3 Camera card slot
Insert your camera card into this slot with the chip on the card facing the front of
the camera. Push the card home until it fits snugly. A camera card is not required
for normal operation of the camera.
Figure 4-4. Camera card slot
☞
Note
Only use an original camera card. Store the owner’s card in a safe place.
CAMERA CARD
