6-6
Operator's Manual - LDK 5000
Operating the Menu System
Files Menu Features
A user of the LDK 5000 camera can have access to 15
different files. This number can be extended by using additional
scene file smart cards. The Files menu is used to recall and
store these files. There are two types of file:
* scene files
* operator files.
A scene file contains values related to the picture performance.
The operator file contains values related to the set-up of the
camera (viewfinder, lens and installation parameters).
The appendix indicates the functions that are stored in the
scene file and those functions that are stored in an operator
file.
Scene files
Four scene files are stored in the camera itself
(SCAM1,SCAM2, SCAM3 and SCAM4). Another four scene
files can be stored on the smart card (SCARD1, SCARD2,
SCARD3 and SCARD4).
A STANDARD scene file (preselected as either factory or
customer defined) is stored in the camera.
Note: The standard customer scene file is stored via the
Security menu, not the Files menu. The decision to
use the factory defined file or the customer defined file
as the standard file is also made in this menu.
The Files menu enables the scene files to be stored and
recalled using the store and recall entries of the menu system.
If the message NOK is displayed then the old values are
restored. If the camera is on-air when a scene file is recalled
then the recalled values do not become active until the
camera goes off air.
Operator files
The Files menu also allows the recall of the opererator file
stored in the camera (OCAM1) or one of the two operator files
(OCARD1 and OCARD2) stored on the smart card. These
files contain information for setting up the non-video
configuration of the camera.
A STANDARD operator files (factory or customer defined) is
stored in the camera.
Note: The standard customer operator file is stored via the
Security menu, not the Files menu. The decision to
use the factory defined file or the customer defined file
as the standard file is also made in this menu.
Install Menu Features
Gain
The gain can be selected in five steps: -, 0, +, ++ and +++. The
actual value of the gain in dB can be assigned to these
symbols. This is done in the Install menu.
Disable camera
The disable camera function is a protection function which
prevents unathorised interference with the camera and
provides an additional level of security. Setting disable camera
to ON is similar to using User level 0 to protect the settings of
the camera.
