5-4
HD video mode
Viper
Standard settings
To ensure that some of the camcorder functions are not set to unusual
values, a standard file has been defined which contains the default
values for most video functions. The table in the appendix lists the
values that are set when the standard file is recalled.
Press the green STD button on the left side panel of the camera and
hold it for 2 seconds to recall the standard values for the various
video functions. The standard values only take effect when the
camera is not recording.
Note:
The standard file can be selected as either a factory or a customer
standard file. Changing the standard file can only be done in the
System security menu if the owner card or the PIN code is used.
Colour Bar
The left side panel also contains a button for switching on the colour
bar test signal. The colour bar is a standard test signal which is used
to set up and check the camera before use.
When the colour bar is selected the following functions are
temporarily set to the values listed below:
Black stretch
:
Off
White limiter
:
Off
Zebra
:
Off
Safe area (VF)
:
Off
Cadre (VF)
:
Off
Operating the camera
Summary of Contents for LDK 5490
