Chapter 3 Servicing and upgrading a PFC 500/E
46
PFC 500/E Instruction Manual
2 December 1999
To remove a disk filler module
Locate the slot where you want to install the disk module, and remove the filler
module, as shown next.
Skip to the disk installation procedure (page 47) to install the add-on disk module in
the slot you just emptied.
To remove a disk module
IMPORTANT: If a disk module has been bound into a LUN, do not move it to
another slot unless you do not care about the data on the LUN. Each module has
LUN identifying information written when it is bound. Moving it to another slot can
make information on the original LUN inaccessible.
Generally, you should not remove a disk module unless its amber check light is on.
Remove the disk module from the slot, as shown next.
Continue to the next section to install the replacement disk module.
Latch
A. Grasp the disk filler module’s
handle so that your thumb is on the
latch.
B. Push the latch, and pull the disk
filler module from the chassis.
Latch
A. Grasp the disk module’s handle so
that your thumb is on the latch.
B. If the active light is on steadily, push the
latch, and slowly pull the module about 1
inch (3 cm) from its slot. Wait 30 seconds
for the disk to stop spinning. Then remove
the module.
If the active light is off or mostly off you do
not need to wait for the disk to stop
spinning. Push the latch and slowly pull the
module from its slot.
