268
Turbo iDDR User Guide
06 July 2005
Chapter 5 Remote Control
Using front panel transport controls
The following describes how to control playout using the transport controls on the
optional front panel. The control application must be configured to allow local
control. (
See “Select the control port and control mode” on page 255
.)
Monitoring remote control communications
The Protocol Monitor button
is displayed in the AppCenter StatusBar when a
protocol application is running on an iDDR channel. The button flashes when any
channel is receiving remote control messages. Clicking the button opens the Protocol
Monitor dialog box which you can use to determine which channels are receiving
messages.
NOTE: The Protocol Monitor dialog will not open until a controller is connected and
at least one command set is sent.
To open the Protocol Monitor dialog box:
• Click the Protocol Monitor button
in the AppCenter StatusBar.
The dialog box displays the channel number and protocol being used, along with
the port number and control mode (Local or Protocol only). The green status LED
indicates the port is receiving protocol commands.
Front Panel Buttons
Action
Play
Play
Stop
Stop
Rew
Previous Frame
FF
Next Frame
Rew(hold)
Rewind until released
FF(hold)
Fast forward until released.
Stop + Rew
Cue previous clip (in a list) or cue to start. This stops playout.
Stop + FF
Cue next clip (in a list) or cue end. This stops playout.
Stop + Rew(hold)
Cue previous clip (in a list) or cue to start. This stops playout.
Stop + FF(hold)
Skip to the start of the preview clip. This stops playout.
Stop + <Select>
Cue the selected clip.
Play + Rew
Play previous clip (in a list) or cue to start and begin playing.
Play + FF
Play next event (in a list) or cue to end.
Play + Rew (hold)
Play previous clip (in a list) or cue to start and begin playing.
Play + FF (hold)
Skip to (and play) the preview clip.
Play + <Select>
Play the selected clip
Summary of Contents for Turbo
