123
6
Getting Started with the Multiviewer
Multiviewer SDC Overview
Architecture
The Multiviewer SDC comprises two software interfaces that are individually configured:
• the Multiviewer SDC software
• that runs on top of the UCP
-
3901 Card’s input/output hardware.UCP
-
3901 Card
Video IP streams are transmitted from or received at ‘spigots’ and may be sent/received on
redundant networks. Destination spigots receive IP streams (IP Rx) and source spigots send
IP Streams (IP Tx). The UCP
-
3901 Card has the following functional inputs and outputs:
• 12 × destination spigots for the Multiviewer video IP stream inputs (IP Rx).
• Multiviewer head outputs:
• 4 × source spigots for mosaic IP stream outputs (IP Tx).
• 4 × mosaic SDI video HD-BNC copy outputs available on the rear panel. See
12G/3G/HD/SD-SDI I/O – Serial digital video inputs / outputs (4)
, on page 26 and
3G / HD / SD SDI I/O – Serial digital video inputs / outputs (12)
Multiviewer Input Scaling
There are 12 image scaling blocks within the multiviewer. This means that:
• There is only one scaling block per input.
• An input can only appear one time on any head display output.
Grass Valley Orbit
The Grass Valley Orbit software tool is used to configure Grass Valley products. RollCall
templates may be viewed and used through Orbit.
UCP‐3901 Card
Multiviewer
SDC
Video IP
Streams: IP Rx
4
Mosaic IP
Streams: IP Tx
SDI, HD‐BNC
12
4
Video Inputs
12
4
4
12 ×
Destination
Spigots
4 × Source
Spigots
Head Display
Outputs
Summary of Contents for UCP-3901
