142
Getting Started with the Multiviewer
TSL Support
TSL Support
TSL Protocol Tally Settings
TSL protocols are used widely throughout the industry for communication between a TSL
Tally controller and Under Monitor Displays (UMDs). The protocol enables tally lamp control
and text label data to be carried to each UMD device.
A TSL Tally controller handles the tally data in a video system and provides TSL Tally control
information to each UMD. The Multiviewer SDC supports two TSL protocols: TSL 3.1 and TSL
5.0. Initial TSL support settings are described here.
Setting up the multiviewer to work with a TSL tally-based system involves the following
steps:
• Specify how the multiviewer gets the TSL Tally message information.
See
Specifying Multiviewer TSL Tally Mode
• Specify index parameters for each UMD on the video wall.
See
Specifying Index Parameters for each UMD
Specifying Multiviewer TSL Tally Mode
The multiviewer may get its TSL Tally information in one of two modes:
•
Server Mode
- Multiviewer SDC listens for Tally messages.
Specify the Multiviewer SDC IP address and network port to receive Tally messages on.
•
Client Mode
- Multiviewer SDC reads Tally messages from a Tally controller.
Specify the IP address and network port number of the Tally controller.
Fig. 6-21: TSL Protocol Operating Modes
The RollCall Control Panel application is used to configure the TSL screen settings. See
RollCall
UCP-3901
Multivewer
SDC
UCP-3901
Multivewer
SDC
IP Address, Port
TALLY CONTROLLER
TALLY CONTROLLER
IP Address, Port
Controller
Sends Out
Messages
Module Listens
Module Actively
Reads Information
a) Server Mode
b) Client Mode
Summary of Contents for UCP-3901
