206
Technical Specifications
RollCall Features
RollCall Features
Communication
Status LEDs
Power Consumption
Connector/Format
Conforms to
IEEE 802.3by - 25 Gigabit Ethernet over fiber
IEEE 802.3 - 25 Gigabit Ethernet over twinaxial cables
a
ST2110-10/20/30
SMPTE-291M/IETF RTP Payload for Ancillary Data
VC-2
AES67
IEEE-1588v2/SMPTE-2059-2
FEC
The UCP
-
3901 supports clause 74 (Base-R) and clause 108 (RS) FEC.
Ensure the network switch you plan to use supports FEC error
correction that you are planning to use for your network.
Video Standards
2160p60, 2160p59, 2160p50 (ST2082-10, mode1 or ST425-5)
2160p60, 2160p59, 2160p50 in quad-link for multiviewer output
only
1080p60, 1080p59, 1080p50 (SMPTE ST274)
1080i30, 1080i29, 1080i25 (SMPTE ST274)
720p60, 720p59, 720p50 (SMPTE ST296)
625i25, 525i29 (SMPTE ST125)
a.Note that when using a 50Gbps breakout cable, ensure that the network switch supports this
feature.
Status
Input and Output status
User memories
None
RollCall/R
Through the gateway or directly through the rear SFP
RollTrack controls
On/off, Index, Source, Address, Command, Status, Sending
Card edge
indicators
, on page 19 for more information.
Power
Consumption
UCP
-
3901-25-EP: 55 Watts
UCP
-
3901-50-EP: 55 Watts
UCP
-
3901-25-MW: 55 Watts
UCP
-
3901-50-MW: 55 Watts
Summary of Contents for UCP-3901
