160
Multiviewer SDC
Sender TPG (Test Pattern Generator)
Sender TPG (Test Pattern Generator)
The
Sender
TPG
page allows test patterns to be applied on a spigot-by-spigot basis at
source spigots (senders of IP streams). The video test pattern is moving color bars.
Figure 7 - 4:
Sender TPG Page
The following options are available for each spigot:
If a test pattern is applied, either a pattern or a tone, the spigot cannot be used for
streaming any other IP flow.
Note:
The test patterns appear at IP outputs only. They do not appear at the
rear panel HD-BNC outputs.
Parameter
Description
TPG
Select the video standard of the moving color bars test pattern to
apply to the spigot from the drop-down list. Select
None
to turn off
the test pattern.
Note:
Different video standards may be selected for the test pattern, if
required. But, for normal operation, the multiviewer head display
outputs from the Multiviewer SDC support high resolution video
standards. Refer to
Multiviewer SDC IP Video Inputs
Audio Freq
Select the audio frequency to apply to the spigot from the drop-down
list.
Caption
Type a caption (max 19 characters) to optionally be displayed with the
test pattern.
Audio dB
Select the dB level to apply to the spigot from the drop-down list.
Show Caption
Set to enable the overlay the caption on the test pattern.
Audio Mute
Set to mute the audio tone.
Summary of Contents for UCP-3901
