39
UCP
-
3901
User Manual
Fig. 4-1: Connecting to UCP
-
3901 Card RollCall Templates from RollCall Control Panel
5 Once connected, install the required licenses for the SDCs you will be using for your
, on page 15 for a list of available licenses.
See
Installing a License into an UCP
, on page 188 to install the license(s).
6 Configure the card.
Connecting to the Multiviewer SDC with RollCall
The Multiviewer SDC consists of two configuration components to which you have to make
separate connections. By default, you connect with RollCall to the:
• UCP
-
3901 Card at the
MANAGEMENT
IP address, at port 2050 (default).
• Multiviewer SDC at the
SFP1
IP address, at port 2051.
To set the IP address of the card’s Ethernet interfaces, see
Local control using the Densité
frame control panel to set the Card’s IP Addresses
PREREQUISITE: The Multiviewer SDC license must have been installed.
By changing a configuration parameter, you can access both configuration components at
the same IP address using a single network connection to the card. You will still use two
different port numbers to individually access the card’s two configuration components. See
also
Proceed as follows.
1 Set the UCP
-
3901 Card’s IP address for the
MANAGEMENT
,
SFP1
, and
SFP2
Ethernet
Local control using the Densité frame control panel to set the
Licensed SDC
See
Essence
Processing (EP)
Multiviewer (MW)
Summary of Contents for UCP-3901
