248
Zodiak Installation and Service Manual
Appendix C — External Interfaces
2.
Touch the type of action in the Action pane at the upper right. Each
action type will bring up the appropriate qualifiers for that action.
Select Source
Action button is selected
and GPI 1 has been programmed to select Source 12 on the M/E 1 A
bus.
3.
Name the GPI input by touching the GPI In Name field and entering a
descriptive name with the alphanumeric keypad.
When the
Recall E-MEM
action button is selected, the menu will appear
similar to the one shown in
.
Figure 167. GPI In Menu – Recall E-MEM Action
4.
In the E-MEM Recall pane, enter the register number you wish to recall
in the Register data pad. Indicate the E-MEM levels to be enabled by
touching the buttons below the Register data pad. Touch
Select All
to
enable all levels.
When the
Master E-MEM
button is selected, the register number in the
Register data pad will be recalled from the switcher Master E-MEM.
When the
Trigger Trans
button is selected in the Action pane, a GPI In can
be programmed to trigger a cut or mix switcher transition on an M/E
bank or the PGM/PST bus with the menu shown in
.
