282
Zodiak Installation and Service Manual
Appendix C — External Interfaces
Krystal and GVeous Peripheral Bus II Control
Configuration
Specific settings are required on Krystal and GVeous systems for Peripheral
Bus II control (
Peripheral Bus II Triggers
Krystal and GVeous Peripheral Bus II triggers are listed in
When Peripheral Bus II is enabled on the Krystal system, Learn and Recall
commands are automatic. See the following section for GVeous system lim-
itations.
GVeous Limitations
The following limitations reside in the GVeous system. The commands
issued by the Zodiak system are formatted correctly. These limitations do
not apply for Krystal.
•
Under Peripheral Bus II control, GVeous correctly recognizes Zodiak
registers 0 through 39. Higher Zodiak registers are not processed cor-
rectly by GVeous, even though the Zodiak system sends the correct reg-
ister number out Peripheral Bus II.
•
Under Peripheral Bus II control, GVeous correctly handles Peripheral
Bus II Learns only when the GVeous current register is 0 through 62.
Table 36. GVeous and Krystal Settings
Menu
Setting
(Krystal) External Control Preference
(GVeous) Remote Enable
Editor port - ON.
Protocol - Peripheral
Baud-38.4kb
Parity - even
Address - (same as Zodiak Device)
Table 37. Krystal and GVeous Triggers
Number
Trigger
1
Run Fwd
2
Run Rev
3
Pause
4
Freeze
5
Unfreeze
