44
Zodiak Installation and Service Manual
Section 2 — Installation
Large Button Film Replacement
With the Main panel still powered down, replace the large button film label
in the PVW/AUX M/E 3 re-entry subpanel location (
as follows:
1.
Using your fingers or adjustable jaw pliers, pull the button straight up
and out of the switch (see
2.
Using needle nose pliers, pull the keycap base out of the lens.
3.
Extract any existing film label from inside of the lens. If the parts are
wedged inside, use sticky tape to remove them. Avoid using sharp tools
that can scratch the lens material.
4.
Insert the new film label and replace the lens on the base. Orient the
label so the notches in the base are located on the front and back.
5.
Re-insert the keycap so the base notches are on the front and back sides
of the switch.
6.
Turn on the Main panel power.
Figure 19. Large Button Film Label Replacement
Lens
Switch
Insert keycap with
notches on front
and back sides.
0646_05_66_r1
Base
Film Label
M/E
3
