66
Zodiak Installation and Service Manual
Section 2 — Installation
See
Power Supply Installation on page 65
to install the power supply. See
to install the Mix Effects (M/E 3) module.
Keycap and Keycap Film Label Replacement on page 41
provides instructions
for replacing the keycaps and the
M/E 3
keycap legend on the Main panel.
CAUTION
M/E Module heat sinks are required for Zodiak software version 2.1 and
higher. Make sure they are installed on every module (including any spares).
Running a Zodiak system without these heat sinks installed can result in
overheating and damage to the M/E modules in your system. See
Heat Sink Installation on page 148
for details.
Module Insertion
Note
It is not necessary to disconnect line power from the Video Processor frame
when removing or installing Video Processor frame modules.
Modules slide into frame slots and into connectors on the frame backplane.
To insert a module, slide it slowly into the correct location, avoiding contact
with the modules above or below. Ensure that you are inserting a module
in an appropriate slot (see
) before applying pressure to seat the
module. The correct location of each module is indicated on the frame door
by module name, and each module is keyed to prevent installation in the
wrong location. For a module to be successfully inserted in any given slot,
the keyholes on the module must match the module keys on the back plane.
Lock the left and right ejector tabs to secure the module.
Module Removal
To remove a module from the frame, disengage the module from its con-
nection to the back plane by unlocking and simultaneously pulling on the
left and right ejector tabs. When the module has been unseated, pull it out
of the frame slowly while avoiding contact with adjacent modules.
KlipCache Option Hardware Installation
The KlipCache option includes a DIMM that significantly increases cache
storage capacity.
CAUTION
Use anti-static practices when handling the memory modules and Control
Processor modules.
Table 7. Module Location
Module
2.5-M/E Slot
3-M/E Slot
Control Processor/DSK/Still Store
1
1
Mix Effects (M/E 1 and M/E 2)
2
2
Mix Effects (M/E 3)
N/A
3
Input/Crosspoint/Sync Generator
4
4
