Zodiak Installation and Service Manual
265
DPM CPL Interface
Zodiak Required Settings
A summary of the Zodiak setups is given in
GVeous Required Settings
lists the GVeous menu settings for interfacing to the Zodiak.
GVEous Configuration Procedure
Define GVeous Device
To define a GVeous DPM device, do the following:
1.
Touch the
Ports & Devices
category selection button at the bottom of the
Eng Setups screen to access the Port & Devices menu (
).
Table 31. Zodiak Configuration Settings for GVeous
Menu
Pane/Category
Setting
Eng Setups - Outputs
(for each Zodiak output
going to Krystal)
Mode
Aux Pair
(if desired, not a requirement)
Aux Bus Pairs
Select Aux Bus for each output.
Aux Bus
(for B Channel of any paired
Aux Buses used by Krystal)
B Channel is:
Key
Eng Setups -Ports &
Devices (define the device,
then use for each source
above)
Define Device
Device Name: Enter descriptive name of GVeous system.
Assigned Serial Port:
CPL 1
or
CPL 2
Device Type:
DPM
Protocol:
DVEous 64 Src
or
DVEous 128 Src
Aux Bus Feeding Channel: Identify Aux Buses used by each
GVeous channel.
Eng Setups - Sources
(for each Krystal source)
Engineering
Name
Enter descriptive name of source.
Source Type
DPM Physical
Table 32. GVeous Settings
Menu
Setting
Remote Enable
Aux or Editor port - ON
LINC - OFF
Protocol - CPL
Baud-38.4kb
Parity - even
Aux Channels - 1, 3, 5, 7
Input Menu
Select AUX control
Select crosspoints on KF by KF basis
