270
Zodiak Installation and Service Manual
Appendix C — External Interfaces
Aux Delegation Mapping
After the Physical and Logical Aux buses have been named and config-
ured, you can assign a Logical Aux Bus to be controlled by any one of the
Aux 1 – 9
buttons in the Bus Delegation subpanel on the Main panel
PVW/AUX bus.
Note
If you will be controlling the Aux buses from the external device, you may
leave the Aux Delegation at the defaults.
To assign an Aux Delegation button to control an Aux bus or Aux bus pair,
touch an Aux Bus button number (
Aux 1
–
9
) from the Aux Delegation pane
in the middle of the screen then touch an Aux bus from the list in the
Logical Aux Buses pane on the right.
As shown in
, the paired Aux buses feeding the DPM Channel 1
(Aux Buses 1 and 2 in this case) are set to be controlled by the
Aux 1
button
on the Main panel. Aux Bus pairs for the DPM Channel 2 are set for control
by the
Aux 3
button.
Figure 181. Aux Delegate Mapping – GVeous Device
