CHARGING a LiPo-Battery:
Example: LiPo battery with 3 cells 2100mAh
Warning: Be careful! Batteries may explode or burn if the charger develops a fault or if the user
chooses the wrong charging program and / or parameters.
5 sec. or
5 sec. or
5 sec. or
3
sec.
3 sec.
- = - - - - - - - -
CHARGE
C: 2.1A 4.2V/C 45°C
CHARGE START 5
PROCESS
[ CC/CV ]
02]LiPo 11.1V 2100mAh
C: 2.1A 4.2Vchg 45°C
ULTRA DUO PLUS 60
GRAUPNER #6478 V1.0
BENUTZERNAME
= - - - - - - - - -
MEMORY [02]
02] LiPo 2100mAh 3S
BATTERY SETUP <1/2>
TYPE
LiPo
VOLTS _3CL 11.1V
CAPACITY _2100mAh
NEW 01.01.2008
CHARGE SETUP <1/1>
CHG CURRENT
_2.1A
CHG VOLTAGE 4.20V/C
CUT-TEMP. 45°C
MAX CAPACITY 105%
SAFETY TIMER 140min
CHARGE START 5
DELAY TIME
____OFF
EXPECT TIME ___0min
EXP.FINSH am00:00:00
00/00/2000 am00:00:00
BATT NAME SETUP<2/2>
01] LiPo 2100mAh 3S
^
ABCDEFGHIJKLMNOPQR
STUVWXYZabcdefghijk
lmnopqrstuvwxyz0123
456789 -.,'#_+/
ä ö ü é è
CHARGE START
[ LiPo ] BATTERY
-- CONNECT --
__ CHECK __
*SELECT CELLS*
Select [3] cells
to be charged or
discharged.
OUTPUT [ _9.932V ]
[ CC/CV ] CHARGE
TIME _0:00:00
CAPACITY ____0mAh
VOLTAGE _0.000V
CURRENT +_0.00A
RESISTANCE __0.0m
BATT TEMP _0.0`F
3 Sec.
-
Use the ‘Dial’ button and the ‘up’ and ‘down’ buttons to
set all the parameters in the Battery Configuration. In
the Charge Configuration press and turn the ‘Dial’
button to set the parameters. Observe the charging
notes in the battery instructions. If in doubt, select a
charge current of 1 C and start with a charge voltage of
4.1 V per cell. The maximum capacity should be set to
105%.
-
Write the battery number on each battery.
-
Connect the battery to the selected charge output, and
connect the balancer plug.
-
Press the ‘Dial’ button to initiate the charge process.
*CONNECTED CHECK* 5
[3] cells are now
Connected at the
Balancing port
.......Right?
OUTPUT [ _9.932V ]
with bal.-
connector
** BALANCER **
** CONNECTION **
** ADVISED! **
First use of the charger A-6
without bal.-
connector
