15 / 28
S5012_Alpha_110_jh_V1
TEST VERSION, DO NOT USE FOR PRINTING
Place the model on a flat surface (cement, mowed lawn or
ground) so that the receiver antennas are at least 15 cm above
the ground. It may therefore be necessary to place a support
underneath the model during the test.
Hold the transmitter at hip level at a slight distance from your
body.
You can start the range test process by pushing simultaneously
the "SPEED + SNAP" buttons.
The red status LED on the transmitter will start to blink quickly
and a signal tone is emitted twice each two seconds.
After the 90 second range test, the transmitter switches back to
full output, and the signal tone stops.
You can stop the range test in every moment by pushing the
POWER button.
During the 90 seconds, walk away from the model and move
the sticks. If you detect an interruption in the link within a range
of about 5 - 10 m at any time, attempt to reproduce it.
Move further away from the model until it does not respond per-
fectly. Move further away from the model until it does not respond
perfectly.
At this location, wait for the remainder of the test period with the
still operable model. The model should still react to control com-
mands once the range test is finished. If this is not 100 % the
case, do not use the system and contact our Service depart-
ment.
Perform a range test before each flight, and simulate all control
movements that could occur during the flight. In order to guar-
antee a safe model operation, the range must always be at least
5 - 10 m on the ground.
Attention!
Never start a range test on the transmitter during normal model
operation!
Factory reset
If it was necessary to erase all the values saved in the copter,
you can make a factory reset. Therefor proceed as follows:
Attention!
all model memories will be deleted!
Push all the trims to the inside and then switch the transmitter
on. In this way all the saved values will be deleted.
