GRAUPNER Alpha 110 Q, Manual

22 / 28

S5012_Alpha_110_jh_V1

TEST VERSION, DO NOT USE FOR PRINTING

Axis assignment

Setup

: Setup: Yes/No

Assignment of the gyros and their operating direction.
In the receiver’s “Axis assign” menu, go to the “Setup” option 

and set it to “Setup: Yes”. Now assign the axes as follow:
On the transmitter, briefly set the roll command fully to the right; 

the roll axis is highlighted. Roll the copter more than 45 degrees 

to the right 

the identified axis with the required prefix is dis-

played, the field is no longer highlighted and identification of this 

axis is complete.
Now do the same for nick: on the transmitter, briefly set the nick 

command so that it is fully forward. Roll the copter more than 

45 degrees forwards; the axis is displayed, the field is no longer 

highlighted and identification of this axis is complete.
Finally complete the procedure for yaw: on the transmitter, briefly 

set the yaw command fully to the right. Turn the copter so that 

the nose turns more than 45 degrees to the right; the axis is dis-

played, the field is no longer highlighted and identification of this 

axis is complete.
The gyros and operating directions have now been assigned. 

Now check to make sure that the operating directions are cor-

rect.

To do this remove the propeller of the copters and give 

approximately a quarter throttle, all motors are running at 

the same speed.
Tilt the Copter in Attitude mode so that its nose is facing 

downwards the front motors must turn faster than back 

ones. Tilt the Copter in Attitude mode to one side  the 

motors of the side, in witch you tilt the model, must turn 

faster then the motors on the other side.

        

            
              
              

              

Step 3
Axis assignment in the gyro