- Copy mod->mod
The model mem is highlighted in the menu screen then press the ENT button. The cursor is on the
select model line. Press the direction button to select the copy mod ->mod line then press the ENT
button to access to the function. When the copy from model screen appears, press the direction
button to highlight the model you want to copy then press the ENT button to accept. When the copy
to model screen appears, press the direction button to highlight the model memory to copy to then
press the ENT button to accept. The message “to be copied YES or NO” appears on the screen.
Press the direction button to highlight YES then press the ENT button to complete to copy. The copy
mod ->mod is automatically displayed. If you press the ENT button after selecting the select model
line then you may check the copied model.
2. m.type + quick (
Aircraft)
The m.type+quick function allows to program the various function of Airplane and Helicopter model.
Always choose model type (Aircraft or Helicopter) before programming any other function of the
selected model type. The function that can be programmed is different depends on the model type,
Aircraft or Helicopter.
•
Motor at C1 : Use the motor at C1 function to set the direction of the throttle channel in the Aircraft
and program to use the throttle channel as the brake in the glider.
•
Tail type : Use the Tail type functions to program the tail mix to match your airplane. 4 tail types (nor-
mal, V tail, delt/flw, 2elev sv appear) are available.
•
Aile/flap : Use the Aile/flap functions to program aile/flap mix to match your airplane 5 aile/flaps (1aile,
1aile 1flap, 2aile, 2aile 1flap, 2aile 2flap) are available.
•
Quick link set : The quick link sett function allows to adjust the D/R expo value and assign the cor-
responding switch to cope with the unexpected situation such as the flight with the strong wind. Since
the adjusted value is activated by moving the switch, you can cope with the crisis with just one switch.
It makes you operating the flight much easier. You can select take off , thermal , dist , speed , acro ,
landing , air-tor , test at quick2 and quick3.
•
Quick link trim : Use the quick link trim function to program the appropriate trims of the quick 2 and
quick 3 in the quick link. The user can program the trim in advance to cope with the unexpected situation
such as the flight with the strong wind and match the flight situation of the takeoff , thermal and speed
of the glider. If the switch is ON, the corresponding trim is activated so the user do not need to set these
trims every time.
11
ENT
ESC
TEL
VIW
ENT
ESC
TEL
VIW
ENT
ESC
TEL
VIW
ENT
ESC
TEL
VIW
ENT
ESC
TEL
VIW
ENT
ESC
TEL
VIW
ENT
ESC
TEL
VIW
ENT
ESC
TEL
VIW
ENT
ESC
TEL
VIW
press
press
press
press
press
NOTICE
: The programming value of the quick link trim depends on the motor at C1, Tail type, Aile/flap
press
press
press
Summary of Contents for HOT TG/mz-12
Page 75: ...No S1002...
