INNOVATION & TECHNOLOGY
REV 1
11
reference! Take this into consideration when you pass it on to other
future owner.
Intended Use
The GR-18 can also be used to control airplane and helicopter models.
To do so you will need to perform a firmware update which can be
downloaded over the internet at
. You also need to download the accompanying
manual describing airplane and helicopter use with the GR-18 flight
controller. More detailed information can be found in the technical data
section. The receiver is designed exclusively to be used in a battery-
powered, radio controlled model, any other use is not allowed.
For any improper use no warranty or liability is accepted. Read through
this manual to familiarize yourself with the product before you attempt
to program or setup the receiver. Graupner constantly works on the
development of all of its products. We reserve the right to change the
product, product functionality and capabilities.
This receiver is not a toy. It is not suitable for children under the age of
14. The installation and operation of the controller must be performed
by experienced modellers. If you do not have sufficient knowledge
about operating radio-controlled models, please contact an
experienced modeller or a model club.
MULTICOPTER Installation
The receiver must be placed in line with one side of the Multicopter.
Secure it to a flat protected space. The bottom of the receiver must
always be parallel to one of the multicopter sides. Secure the receiver
with high quality double-sided tape to reduce any vibrations that may
affect accurate operation of the receiver.
Binding
The binding is only possible if the receiver has not yet been bound to
another transmitter (red LED blinks). Pushing the SET button the
receiver will be set in Bind mode.
If you want to bind an already bound receiver to another receiver,
follow the next steps:
Turn off the RF module in the
your radio manual)
Switch on the receiver and push the SET button to bring it to
bind mode. Press bin
menu.
When the red light turns off and the green LED light turns on,
the binding was successful.
