INNOVATION & TECHNOLOGY
REV 1
5
High intensity LED light system
External JST power bus for FPV equipment
FLIGHT PREPARATIONS
Your Alpha 250Q comes pre-assembled and all settings on the flight
s
have been pre-wired and their rotation direction have been set at the
factory.
Alpha 250Q RTF Preparations
Do not attach the propellers until instructed!
1.
Charge the 3S LiPo battery using the supplied LiPo Balancer
Charger S2015 by inserting the rectangle balance plug from
the battery into the charger 3S (11.1V) balancing port.
Charging may take up to 10 hours depending on the state of
the battery.
2.
Install the supplied AA batteries into the mz-12 radio and
check its operation by turning it on.
3.
Before attaching the 3S battery to the Alpha 250Q make sure
that the throttle stick is all the way down and that switch S1
on your mz-12 radio is switched off (pointing towards you).
Switch S1 is your throttle on/off switch acting as an added
safety for accidental motor activation.
4.
After attaching the battery a range of beeps will be heard
indicating that the motors are armed and ready for operation.
