GRAUPNER HoTT MC-16 Series Programming Manual Download

Page: 88 / 332

Program description - Base setup models | Winged models

bind

BD1

BELE

BD2

Rcv

R08

Mod.

Stick

modu

Base setup model

must be

OFF

Press the central

SET

button of the right-hand four-

way button to erase the message.
Drop down two lines in the screen and switch off the
RF module as described on the page in section “RF
module”. Afterward, return again to the “Module” line
and restart the binding process as described above.
Alternatively, the transmitter can be switched off
briefly then, after switching it back on again, respond
to the message window that appears …

P l e a s e s e l e c t

R F o n / o f f ?

O N

O F F

… with “OFF” …

P l e a s e s e l e c t

R F o n / o f f ?

O N

O F F

… then confirm the selection with a brief tap on the
center

SET

key of the right four-way button. From the

base screen jump again into the “Module” line of the
»Basic settings, model« menu and restart the bind-
ing process.

Dissolving a bond
Proceed as described above to initiate the binding
process but WITHOUT first putting a receiver in bind-
ing readiness.

EXT.

(PPM signal at DSC socket)

If your transmitter is fitted with a non-Graupner|SJ
external RF module connected to the DSC / Data
socket, you can switch between the standard internal
HoTT RF module and the external module when you
switch model memories in the “Module” line by choos-
ing either “HoTT”, “EXT.”, or “SP.”, as described in the
following section.
You can now use the arrow button



of the right-hand

four-way button to move to the first Value field in the
“Module” line before pressing the central

SET

button

of the right-hand four-way button:

bind

BD1

GRAUBELE

BD2

Rcv Ch Map

R12 R08

Mod.name

Stick mode

module

Base setup model

HoTT

In the active Value field you should now use the Se-
lect buttons to choose “EXT.” or – if appropriate – the
“SP.” mode (described below) instead of “HoTT”.
When you select “EXT.”, the HoTT-specific value fields
are replaced by the modulation type already selected
in the “DSC output” line; see page 92:

PPM10

GRAUBELE

EXT.PPM sig.

normal

Mod.name

Stick mode

module

Base setup model

EXT.

The lines of the “Receiver output” and “Range test”
options (described below) are also suppressed, as
are all the HoTT-specific displays in the base display;
“PPM” is also superimposed instead of “HoTT”:

GRAUBELE

#01

0:12h

Stp

Flt

0:00

4.0V

PPM

Press the central

SET

button of the right-hand four-

way button to conclude the Select process.

SP.

(digital signal at Data socket)

However, if you require a special digital signal instead
of the analogue PPM signal for the non-Graupner|SJ
external RF module, then connect this to the DATA
socket and select “SP.” in the “Module” line:

GRAUBELE

SP channel

SP.

BIND

Mod

Mod.name

Stick mode

module

Base setup model

Once again, press the central

SET

button of the right-

hand four-way button to conclude the Select process.
The lines of the “Receiver output” and “Range test”
options (described below) are also suppressed, as
are all the HoTT-specific displays in the base display;
“SP.” is also superimposed instead of “HoTT”:

GRAUBELE

#01

0:12h

Stp

Flt

0:00

4.0V