Assemble the transmitter’s rear case and switch to mode 2 from mode 1 at Stick mode page
in the transmitter programming setup section according to the manual.
Ratchet Type Options and Strength Adjustment for Throttle Stick.
There are two options for the ratchet type of throttle stick. The one is clank type generally operat-
ing airplane and the other one is no-clank type usually operating helicopter.
The right sided screw of the black-colored circles on the below picture is for strength adjustment
of throttle ratchet spring in case of operating helicopter (no-clank type).
The left sided screw of the black-colored circles on the below picture is for strength adjustment
of throttle ratchet spring in case of operating airplane (clank type).
Therefore, you can pick your required type by tightening the related screw (left screw for air-
plane; right screw for helicopter).
Please refer to the below picture, you can adjust the screw.
The sticks of mz-12 Europe Version shall be operated by tension Modes.
According to the below picture with guideline, after disabling the other side stick, you can pick
the throttle channel of mode 1 or 2.
The method of Disabling Tension
The both sticks could be used tension or throttle types according to the users.
At first, you can open the case of Transmitter.
If you turn the screw clockwise at the blow black-colored circle, the tension function shall be
disabled.
If you want to use the one stick by throttle function, you can disable the tension of the stick.
Please refer to the below picture, you can adjust the screw.
9
10
Assemble the centering cam into the
throttle gimbal of mode 1 transmitter
and set the spring in the center
control part and the centering cam
with tweezers
Screw the disassembled tension
control bolt from the elevator gimbal
of mode 1 transmitter into the throttle
gimbal and adjust the bolt for the
desired control
Tension spring
7
Make sure to test all functions are normally operated in mode 2 before flying
NOTICE
Summary of Contents for m-12 HOTT
Page 77: ...mz 12...
