Ch6 = Pitch
3 servo (120°)
Ch2 = Aileron
Ch2 = Elevator
Ch6 = Pitch
Throttle Cut Switch
This function assigns the Throttle Cut switch to the push
button located on upper right front of the transmitter.
The Throttle Cut function is designed to return the
throttle trim to the lowest position instantly and keep this
position while the button is pressed. This feature is used
to “cut“ or stop the engine without changing the position
of digital throttle trim.
Function mode HELICOPTER
Throttle Cut Switch; Throttle Hold
Function mode HELICOPTER
29
Throttle Cut Operating position
(-32~-128)
Go to Throttle Hold
menu
Go to Travel adjust
menu
Change value
Set function to Inhibit
Accessing the Throttle Cut Function
1. Place the transmitter power switch in the ON positi-
on.
2. Access the Function mode. To do so, press the
Down
ans
Select
keys simultaneously. Press
either the
Up
or
Down
key until
THRO CUT
ap-
pears in the upper portion of the LCD screen.
3. Us the (+) and (-) keys to change the value of the
Throttle cut function.
Note:
Pressing the Clear key will Inhibit the Throttle
Cut, turning it off until it has been reactivated.
4. Access the
TRAVEL ADJ
mixing function by pres-
sing the
Down
key.
5. Access the
THROTTLE HOLD
function by pressing
the
Up
key.
6. Exit the
THRO CUT
function by pressing the
Down
and
Select
keys simultaneously.
Throttle Hold
The Throttle Hold function is designed to hold the thrott-
le servo in a specific position during an autorotation.
This is very useful for practicing autorotation landings.
The throttle hold switch can be programmed to one of
the four toggle switches. Throttle hold will always be
“On“ in the forward switch position and “Off“ in the rear
position.
Press +/- key
Press CLR key during selecting
SW
Go to Throttle Curve
menu
Go to Throttle Cut
menu
Select function to
change
Change value/SW
selection
Reset POS value to 0
or Inhibit function
Throttle Hold Position
(-20~50)
Hold SW Select
Switch
LEFT
: THRO HOLD SW Forward Side
On
AILE D/R : AILE D/R: AILE D/R SW Position 1
On
ELEV D/R : ELEV D/R Position 1
On
RIGHT : FLIGHT MODE SW Forward Side
On
Accessing the Throttle Hold Function
1. Place the transmitter power switch in the ON positi-
on.
2. Press the
Down
and
Select
keys simultaneously
to enter the Function mode.
3. Press either the
Up
or
Down
key until
THROTTLE
HOLD
appears across the top of the LCD.
4. The factory setting for the throttle hold is inhibit.
Pressing either the (+) or (-) key will activate Throttle
Hold and display the current throttle hold value.
5. Using the (+) or (-) key, adjust the throttle hold
value to deliver the proper engine idle rpm for your
helicopter. The adjustable range is (-20% -/+ 50%).
Once you establish the proper idle value for your
engine, you can use this value for throttle hold as
well. To shut the engine off for autorotation, a negati-
ve or zero value should be input.
Note:
When the throttle hold is activated, and the
switch is on, the indicator on the LCD will
change from Off to On. In addition, the throttle
trim indicator will be inhibited.
6. Access the
THROTTLE CURVE
function by pres-
sing the
Up
key.
