285
Detail program description - Control adjust
H
+100%
+50%
Pitch
nor mal
+50%
Input
Output
Point
Cur ve
off
Notice:
A rotor adjustment gauge, such as the Graupner
adjustment gauge, Order No.
61
is very useful in reading
the angle.
Now move the pitch joystick toward the pitch minimum
position until its limit position. Depending on the ability
of the pilot, adjust the value of point "L" so that the blade
angle of approach is 0 to -4 °. Now a slightly pitched line
arises at the hovering points, the so-called pitch curve,
which can appear as follows:
L
–100%
–75%
Pitch
nor mal
–75%
Input
Output
Point
Cur ve
off
Now you can, if you like, move the marking frame
upward with the arrow keys to the "Curve" line and after
activation of the value fi eld by briefl y pressing the central
SET
key of the right touch pad, set the curve function of
the mixer to "on".
L
–100%
–75%
Pitch
nor mal
–75%
on
Input
Output
Point
Cur ve
If you now switch to autorotation phase – at the bottom
left of the display the fl ight phase name "Autorot"
appears – the "old" pitch curve is again:
?
0%
0%
0%
Pitch
Autorot
Input
Output
Point
Cur ve
off
Now carry out the same setting as before in the normal
phase. Only at point "H" – at pitch maximum – the pitch
angle can be increased by approximately 2 °. In doing
so, you will have somewhat more of an angle to catch
the model later on (1).
After setting the pitch curve, move the autorotation
switch back and return to the helicopter mixer menu
selection by briefl y pressing the central
ESC
key of the
left touch pad. From there, switch to the line
"
C1
Thro
" in order to adjust the throttle curve.
First the adjustment range of the idle trim must be
adjusted with the throttle curve. For this purpose, move
the pitch joystick to its minimum position and then set
point "L' to approximately -65 %.
–100%
–65%
C1
Throttle
nor mal
L
–65%
Input
Output
Point
Cur ve
off
With the throttle limiter
closed
and the idle trim
completely open, move the pitch joystick back and forth
somewhat at the minimum limit position. The throttle
servo may not move with it in the process. No you have
established a seamless transition from the idle trim to
the throttle curve. The further settings along the throttle
curve must be carried out later in fl ight.
If you switch from this graphic to the autorotation phase
for testing purposes, the following appears instead of the
accustomed representation:
OFF
C1
Throttle
Autorot
That means that this mixer is switched off and the
throttle servo is switched to a fi xed value, which can be
adjusted as follows:
Return to the menu list by pressing
ESC
. As long as you
are still in the autorotation phase, new submenus are
listed; specifi cally:
Summary of Contents for mx-20 Hott
